102C10 | PCB製品・検索見積りサイト東陽テクニカ

Model: 102C10
Cryogenic ICP® pressure sensor, 100 psi, 50 mV/psi, 3/8-24 mtg thd, safety wire holes. Operating temperature range of -400 to +212F (-240 to + 100C)

Specifications
アクセサリ
Product Documents

■ Specifications

Performance
Measurement Range (for ±5V output)	690 kPa
Useful Overrange (for ± 10V output)	1380 kPa	[4]
Sensitivity (±15 %)	7.25 mV/kPa
Maximum Pressure (step)	6900 kPa
Maximum Pressure (Total)	103425 kPa	[3]
Resolution	0.014 kPa	[2]
Resonant Frequency	≥250 kHz
Rise Time	≤2.0 µ sec
Low Frequency Response (-5 %)	0.50 Hz
Non-Linearity	≤1.0 % FS	[1]
Environmental
Acceleration Sensitivity	0.0014 kPa/(m/s²)	[2]
Temperature Range (Operating)	-240 to +100 °C
Temperature Coefficient of Sensitivity	≤0.108 %/°C
Maximum Vibration	19600 m/s² pk
Maximum Shock	196000 m/s² pk
Electrical
Output Polarity (Positive Pressure)	Positive
Discharge Time Constant	≥1.0 sec
Excitation Voltage	20 to 30 VDC
Constant Current Excitation	2 to 20 mA
Output Impedance	<100 Ohm
Output Bias Voltage	8 to 14 VDC
Physical
Sensing Element	Quartz
Housing Material	304L/316L Stainless Steel
Thread Adaptor Material	316L Stainless Steel
Diaphragm	316L Stainless Steel
Sealing	Welded Hermetic
Electrical Connector	10-32 Coaxial Jack
Weight	11.00 gm

All specifications are at room temperature unless otherwise specified.

Product Notes

[1] Zero-based, least-squares, straight line method.
[2] Typical.
[3] Due to high sensitivity, the static pressure should be applied and removed very slowly. Rate should prevent more than 10 Volt change in output until Output Bias Voltage returns to normal (approximately 15 times discharge time constant).
[4] Excitation voltage >=28 volts required.
[5] See PCB Declaration of Conformance PS023 for details.

Accessories:

No Accessories

Optional Versions:

( M ) Metric Mount

Accessories:

065A34

Seal ring 0.435" OD x 0.397" ID x 0.030" Cu

■ Documents & Downloads

Product Documents

● Product Manual

● Product Specification Sheet