Procedure for Reinstalling EMC Measurement Software Ver.1.0
This document shows the procedure for installing TOYO EMC software on a new PC when the old one has been renewed or has failed. If you encounter any question and/or problem during the installation, contact TOYO Corporation EMC Support Center at:
Before Installing Software
Make sure that you have the following CDs:
•GPIB Driver CD
•Software Installation CD
Make backups of all the files in the following folders on your current PC:
*Note: You do not need to make backups of the dll files and exe files specified
•Drivers common to all instruments controlled by each software:
C:¥Program Files¥Common Files¥TOYOVI （except for dll files）
C:¥Program Files¥ "model name" (except for exe files)
•In the case of EP5/RE Conducted Emission Measurement Software:
C:¥Program Files¥ EP5RE (except for exe files)
•In the case of IM5/RS Radiated Immunity Measurement Software:
C:¥Program Files¥ IM5R (except for exe files)
Now you are ready for the installation.
(1) Installing GPIB Driver and Making Setting
Install the GPIB driver that we delivered with our EMC measurement software.
After that, you
How to make settings for GPIB board:
Go down "Start" => "All Programs" => "National Instruments" =>
"Measurement＆Automation". (You can boot up "Measurement ＆ Automation" also from the icon to be made on the desktop after the GPIB driver installation.)
Go down "Devices and Interfaces" => "GPIB0" and select "Properties" (see above).
Make sure that all the settings on your PC agree with those in the above window; if there is any discrepancy, correct it. (Please note that the settings enclosed by red circles in this window are different from the default settings.)
(2) Installing Application Software
Find "SETUP.EXE" in the EMC software folder on the CD that we delivered, and double-click it. Then the left-side dialog below will appear.
Click "Next" until the upper right-side dialog appears and asks you to select the folder to install files in. To change the default setting, click "Browse". Once you determine which folder to install files in, click "Next".
Then the left-side dialog below will appear, asking you to click the type of setup you prefer. Click "Typical" and then "Next".
The upper right-side dialog will appear to add program icons to the Program Folder (in the Startup Menu). If you prefer to change the default setting, change the folder name and click "Next". Then installation will start.
Once the installation is correctly completed, the dialog above will appear.
(3) Installing USB Protection Key（If your protection key is of the old type to be connected to the printer port, you do not need to make the setting below.）
If you connect the USB protection key to a USB port, a hardware search wizard (below left) will appear. Check the middle radio button in the wizard (below left) and click "Next".
Check the radio button for "Install from a list or specific location [Advanced]" as in the right-side wizard window above, and click "Next".
Check "Include this location in the search" and click "Browse" as shown in the window left below, and then specify the following folder:
Click "Next", then installation of driver will start. The installation is correctly completed, then "Completing the Hardware Update Wizard" dialog will appear. Click "Finish".
[Note] After installing a driver, you need to reboot the PC to have it recognize the USB protection key.
(4) Transferring Backup FilesSave the backup files prepared in in the same folders.
This is the end of the procedure. Boot up your TOYO EMC software and test its operation.
- EMC English Site Top
- EMC Solutions
- EMC Measurement Software
- TOYO's Affiliate & Distrbutors in Asia
- Original EMC Products
- Technical Information
- Start of dealing in New EMI receiver of Agilent Technology
- Pre-Compliance EMC Test Solutions
- Establishment of TOYO Corporation China
- Compliance EMC Test Systems